Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

12.06.2025 02:49

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

It also is a device that limits the change in current flow.

eight

Do most narcissists have good intentions as long as you are under their control?

what exactly is a ‘surge’ protector?

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

What caused the Democratic Party's 2024 presidential campaign to implode so horrifically?

[image of Common-mode choke]

The third is lightning and “how it gets conducted into a home.”

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

Nintendo Switch 2 Size Comparison vs. Original Switch vs. Steam Deck - Gizmodo

(Dc diagram shown, AC is similar).

At one ohm, the resistor has a maximum of 1 watt power.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

What was your most embarrassing wardrobe malfunction in public?

Upvotes:

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Google’s NotebookLM now lets you share your notebook — and AI podcasts — publicly - The Verge

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Edit 2024–10.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

What happens when you get sick in a country with universal healthcare? What's the process like?

It seems Mohan does not understand the difference between a comment and an Answer.

So, the voltage could go up to 500 volts, and the fuse will not open up.

He then describes the function of a fuse.

Two of my family members have recently converted to Islam and have brought shame on my family. How do I get them back into the fold of Hinduism?

Here is a simplified AC power diagram.

but this device (an Inductor) … impedes the rapid changes in the current.

One is “what exactly is in a ‘surge protector’ ? ”

What are incels doing wrong?

so, what happens?

This is where this question deviates from being a 'generic' question, and becomes more specific.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

How has your life changed for the past 10 years? Can you share your #10year challenge? Is your life better, worse, or still hopeful?

For this case there are devices called Metal oxide varistors (MOV).

But… the neutral is now “floating” because of the 1 ohm resistance.

2024–10–16 [ OO OLAOYE OYEBODE ]

What are the potential benefits of going without clothes at home for a few days without any specific reason?

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

A circuit breaker is similar, but is resettable.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

Companies are struggling to fill manufacturing positions, let alone plan for what Trump's administration has in mind - Business Insider

2024–10–14 [Omar Gharbi Omar Gharbi ]

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

This is 'the assistant's answer'

Why are US customs agents so talkative? I cringed hard when a US customs agent asked me if I was on vacation. He doesn’t need to know why I went to another country as long as I am a U.S. citizen.

An AC voltage/ current source, and an ac inductive load.

Barnstars:

At least they know the answer if they wanted it.

What makes females believe or think abortions are part of a woman’s rights?

In schematic diagrams this is the symbol for a fuse:

These devices are installed between the “hot” and “neutral” and protective ground.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

Dejected Joshua Kimmich reacts to Germany’s Nations League defeat - Bavarian Football Works

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

How short is too short for a skirt?

Because the load is inductive, the current lags the voltage.(by a bit).

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

Now when you have a certain ac resistance, then a current flows in a loop.

This device then solves the entire problem.

First Sentence:

What is lightning?

The MOV will conduct when the voltage exceeds 50% of line voltage.

[old diagram got deleted by accident]

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

These are simplified answers to the original question, and does not change anything I wrote above.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

a photo is worth a thousand words.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

the problem then depends on "how fast does the fuse operate?".

This is where the MOV conducts again, and dissipated the energy.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

One

2024–10–10[John johnson John Johnson ]

There are three different concepts here that are getting confused.

This one hit behind the barn.

What does a fuse do?

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

but I think this circuit , shows a few more pieces.

nine

I post the exact comment here.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

He then describes Rainy Season and Lightning.

He then asserts :

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

A fuse is a non-resetable over current circuit protector.

The other is “what does a “fuse” do?”

There are two important concepts here.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

The bolt then partially travels down the line to your home.

But it can get overloaded, and no longer works.

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

This is the picture of an electronic coil of wire wound around a core of magnetic material.